Outer Fiber – Page 4

Tag: Outer Fiber

61 Posts

Others, Photos, Photos & Info

Victas Liam Pitchford [Photos & Information]

January 28, 2024 — 5 Comments

Report

KTS Fury KC & Fury LC [Lab Test Report]

January 18, 2024 — 7 Comments

Report

Tibhar MK Carbon [Full Review]

January 12, 2024 — 42 Comments

Report

Victas ZX-Gear Out & ZX-Gear In [Lab Test Report]

January 3, 2024 — 38 Comments

Report

Nittaku Mima Ito Carbon (Acoustic Carbon) [Full Review]

December 20, 2023 — 25 Comments

Others, Photos, Photos & Info

Victas ZX-Gear Out [Photos & Information]

December 5, 2023 — 2 Comments

Report

andro Synteliac ZCO & Synteliac VCI [Lab Test Report]

November 22, 2023 — 24 Comments

Report

Yinhe Mars (PLC) series [Lab Test Report]

November 7, 2023 — 18 Comments

Others, Photos, Photos & Info

andro Synteliac ZCO OFF/S [Photos & Information]

October 24, 2023 — 4 Comments

Report

Xiom An Jaehyun TMX & An Jaehyun TMXi [Lab Test Report]

October 23, 2023 — 59 Comments

Thank you very much for the review! I've been thinking about trying this blade after the Xiom HAL, and it…

I'm not sure I got this: does this have carbon or not? The old donic relevant (before coton) used to…

Stop using AI to write this. But if you must, at least proofread before you publish. "As its name expresses,…

Thanks a lot! Currently I use this one. And now I can understand it better with numbers. Great job as…

Hello Dude, is ep/ec Number show the Blade stiffness? Higher number of ec/ep Is stiffer tahan lower number?

La Ec es superior a la Ep o se ha cambiado el orden, con las gráficas vuestras actuales todas las…

Thanks for your continued efforts! I am always looking forward to reading your reports. You seem to post a lot…

Always good information

I have read through the valuable information you provided, and it seems that the weight of the racket may have…

I've played with this blade for sometime now.Used Rakza Z on FH and Nuzn 55 on BH. With this setup…

What about 729 Yellow ALC? It's a low cost inner ALC blade, but I feel very well with it, thanks.

Could you review the Stiga I1?

thank you for the analysis! I am learning these measurements to better help myself decide the next blade. it feels…

Do you think the Nittaku Septear would still be Relevant in the coming years? I am planning to buy one,…

Hello, If I want to test this Stiga Cybershape Carbon, do you recommend using it with very hard rubbers (like…

Which new Rubber is like the Adidas P7?

Thank you very much for your reply. I'm really looking forward to seeing the results of your measurements. Do you…

Actually i managed to find a close enough replacement after reading your review and that is Victas firefall VC. Not…

Unfortunatly I couldn't have got that blade. When I tried it was out of stock, and the distributor doesn't have…

Thank you for information.

Absolutely not! Its head size is 157mm x 150mm. (There can be small differences in actual products. for example 156…

In fact, HL5 is the same blade as B2. The difference is in quality. So HL5 will be the solution…

That differs case by case. Both of Ep and Ec increase when the thickness of blade increases. The ration is…

Thank you for comment! :-)

TTGearLab

Engineering & Graphic Design of Table Tennis Equipments

Tag: Outer Fiber

Victas Liam Pitchford [Photos & Information]

KTS Fury KC & Fury LC [Lab Test Report]

Tibhar MK Carbon [Full Review]

Victas ZX-Gear Out & ZX-Gear In [Lab Test Report]

Nittaku Mima Ito Carbon (Acoustic Carbon) [Full Review]

Victas ZX-Gear Out [Photos & Information]

andro Synteliac ZCO & Synteliac VCI [Lab Test Report]

Yinhe Mars (PLC) series [Lab Test Report]

andro Synteliac ZCO OFF/S [Photos & Information]

Xiom An Jaehyun TMX & An Jaehyun TMXi [Lab Test Report]